IMG Home PageIMG ProductsProduct DownloadsOrdering InformationTechnical Support and Frequently Asked QuestionsDeveloper's Corner and UtilitiesAbout IMG
CustomersIMG ResellersMedia InformationIMG Events / Trade ShowsUseful LinksIMG Contact InformationIMG Information / Policies


Joystick-To-Mouse Command Line Options

This section documents the available Command Line options. Typically this is appended to the startup command (Target), i.e. "C:\Program Files\Joystick-To-Mouse\JOY2MSE.exe SOMEOPTION" in the shortcut.

NOSPLASH

The NOSPLASH option can be placed on the command line / startup shortcut, and this will force the splash screen to be bypassed and not shown.

TOUCHSCREEN

The TOUCHSCREEN option can be placed on the command line / startup shortcut, and this will force the check for the physical mouse to be bypassed and no warning/failure will occur, so Joystick-To-Mouse can be run on a system without a physical mouse.

Note: When Joystick-To-Mouse is started via the "Run at Start Screen" option, the JOY2MSE_RUN.exe is used to launch Joystick-To-Mouse, so using this command line is not possible. As an Administrator, if a file named TOUCHSCREEN.INI is created (file contents are not used, only the files existence) in the same folder as JOY2MSE.exe (e.g. \Program Files\Joystick-To-Mouse), then this will act as if the command line option is used.


IMG Home PageIMG ProductsProduct DownloadsOrdering InformationTechnical Support and Frequently Asked QuestionsDeveloper's Corner and UtilitiesAbout IMG
CustomersIMG ResellersMedia InformationIMG Events / Trade ShowsUseful LinksIMG Contact InformationIMG Information / Policies


As seen in ...

Yahoo!finance